|
Photo Etch Brass Chassis SM Range |
|
Thank you for purchasing one of our precision photo etched chassis. This
chassis is designed for Scalextric Mabuchi type motors with endbell drive
shaft end and any of the following guides. Ninco sprung guide part no
80106, Scalextric guide no G21 and slotted wooden track guide no
SICH07.
1) Cut the front, rear and guide plate components from the frame and from each
other with cutters, strong blade or dremmel. File off any rough remains of
tags.
2) Note always fold towards the etched fold line fig (1). Working along the sides
with a pair of pliers ease up the side rails of the chassis in two or three gentle
stages until the sides are 90’ to the base fig (2)
3) Do the same to the rear plate and clip pegs on side rails into holes in rear
plate. (On chassis with rear body mounting hole bend tag down to form 90’ to
rear plate)
4) Fold up side of front chassis as at (2) above
5) Fold up guide mounting as shown both upright faces first. Fold over top face
so that peg on left side clips into hole in top face.
6) Slide guide mounting plate into rear half of chassis.
7) Slide chassis front half into rear half and bend over locating tags on rear half
8) Adjust to correct wheelbase and select your desired guide position before
inserting the screw from underneath and tighten nut down from above.
|